Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 15 - Jul 20
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Skystars F7HD Stack F722HD Pro 4 Flight Controller & KM65A F4 128KHz AM32 65A 4in1 ESC - 30 x 30mmSkystars F7+KM65 is a powerful stack for 5" freestyle and racing drones or 7 8" long range drones. The flight controller with modern F7processor has 16MB memory for blackbox and 5V 3A and 10V 3A BEC. The flight controller can be conveniently used on a drone with both digital and analog video transmission. The pads for connecting the LEDs are in the corners. The integrated barometer for altitude measurement also comes in handy. The KM65 ESC supports 3
Skystars F7+KM65 is a powerful stack for 5" freestyle and racing drones or 7-8" long-range drones. The flight controller with modern F7processor has 16MB memory for blackbox and 5V/3A and 10V/3A BEC. The flight controller can be conveniently used on a drone with both digital and analog video transmission. The pads for connecting the LEDs are in the corners. The integrated barometer for altitude measurement also comes in handy.
The KM65 ESC supports 3-6S battery power and current up to 65A, which makes it playfully handle motors of size 2207-2808. The ESC has an aluminum heat sink on top to help dissipate heat better while protecting sensitive components from mechanical damage. The ESC uses a powerful F4 32-bit processor and AM32 firmware. Thus it supports telemetry, bidirectional DShot and PWM frequency up to 128KHz. The ESC is protected against voltage spikes by a TVS diode.
Check out all our Stacks and the rest of our Skystars Products!
Features:
- 1. Solder pads are the largest in size compared to other FC in market.
- 2. Proper solder pad spacing to avoid solder bridge and facilitate easy soldering.
- 3. ESC connector on top-side rather than bottom which makes it easy for repair.
- 4. TVS Diode for Reverse Polarity Protection and Voltage Spike Suppression.
- 5. Powerful 3A BEC to supply all your electronics.
- 6. Pads arrangement are executed in such a way that when you twist the wires of the camera VTX and RX you don't get any wire overlapping this gives you a uniform twist and clean look.
- 7. Support DJI O3 connector on the top side.
- 8. Support VTX ON/OFF Pit Switch.
- 9. Gyroscope independent power supply, No power lines near MPU6000 Gyro to avoid any EMI interference.
- 10. Two stages of Quality check to reduce any faulty electronic.
- 11. Comes ready with I2C support and INAV.
FC Specifications:
- MCU: STM32F722RET6 216MHz
- Gyroscope: ICM42688P
- Baro:Bmp280
- OSD: Betaflight SPI OSD DJI HD OSD(UART6)
- Black box: 16MB
- 6x Uarts: UART 1/2/3/4/5/6
- 4x PWM outputs
- 1x I2C
- 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
- USB Type-C(USB2.0)
- 1x JST-SH1.0_8pin connector (Gnd/Vbat/S1/S2/S3/S4/Rx3/Curr)
- 1x JST-SH1.0_6pin connector (10V/Gnd/TX6/RX6/Gnd/Sbus)
- VTX 10V/Vbat filtered power ON/OFF Pit switch
- DJI FPV OSD is supported by any spare UART
- LED: 4 LED independent pads, support WS2812 programming lamp output.
- Receiver: Support Sbus, crsf, ibus, SBUS, XBUS, support 3.3v Spektrum satellite receiver, The default receiver input is UART1(You can solder ELRS RX on UART1), F7 has a built-in inverter, which can actually be installed in any spare UART.
Power:
- Input voltage: 3-6S
- BEC: 5V/10V 3A dual-channel BEC supports stable power supply on the sky side of DJI O3
- LDO 3.3V: Max.250mA
- Flight control onboard voltage sensor.
FC Firmware:
- BetaFlight firmware: SKYSTARSF722Pro
- INAV firmware:SKYSTARSF722HD
Mounting:
- Installation size: 30.5mm × 30.5mm The installation hole is M4 and supports shock column installation
- External size 39mm × 39mm
- Flight control weight: 6.9g
AM32-65A 4IN1 3-6S ESC BLheli32 128K DShot1200 4-in-1 ESC Specifications:
- Support 128K Dshot1200, Dshot600, Dshot300, Dshot150, Oneshot125, Multishot, PWM control signal
- Excellent over-current capability.
- Extreme stably support 6S LiPo battery with TVS.
- Excellent heat dissipation performance
- Better control performance F4 core MCU support 128K.
- Input voltage: 3-6S LiPo
- Con.Current: 65A
- Peak Current: 90A≥ 10S
- Firmware: AM_32
- Support : Dshot 600/1200
- Mounting hole : 30.5mm/M3
- BEC: No
- Product size: 45.6*45*7.6mm
- Weight: 19g
Package Includes:
- 1x F7HD Pro4 FC
- 1x KM65 128K AM32 4IN1 ESC
- 8x Silicon grommets M4 to M3
- 2x JST-SH1.0_8pin cable, 4cm
- 1x JST-GH-6P cable for DJI port, 10cm
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.6 ★★★★★
Based on 2457 reviews
Sort
Product Reviews
★★★★★ 5
Great staple slip dress
This dress is more on the expensive side for a slip but it is SO cute and flattering. The low cut back is stunning and the material is soft and has some give to it. Super simple and sexy.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 23, 2025
★★★★★ 5
Loved them so much- Bought another pair
To start off, I have wide feet, ankles, and calves, because i'm a bit on the heavier side. Finding shoes that fit these requirements are difficult. The top part of the shoes that hug my legs are actually still a little roomy. Someone who has slightly larger lower legs can fit into these as well. If you have tiny legs, these shoes may be a little too loose, or if you don't have wide feet. These shoes are literally perfect for my feet and legs. The back unzips so I was able to get my feet into the shoes easily, and even wearing them I didn't feel like my toes were being squished. I ordered a size 10, and it is perfect length and width for my wide feet. Do note: My feet are wide enough to not fit in most shoes, but not too wide, you should pay attention to the measurements if you have wide feet.
I was a little skeptical from a review of a woman who had her toes bleeding from these shoes, as I know that is often a problem for me with most shoes I wear. Generally I start bleeding in the back of my heel. So I was skeptical that these shoes would make me bleed. However, I was proven wrong. These are one of the only shoes i've worn that haven't rubbed my skin right off. I believe that has to do with the lovely height of the back, which prevents rubbing on the back of your heels, and the perfect width of the shoes. If your feet are too wide for these shoes, then you will probably bleed, but that's to be expected because the shoe does not fit you and that is often something that can happen with shoes that don't fit.
I originally bought the green pair, because I loved the color, but then I loved the fit so much that I bought a second, black pair. These are one of the only shoes with heels I actually wear because they are more comfortable than most, and they're just adorable. I am not generally a high heel wearer, so I'm not used to walking with my heels elevated. Despite that, these shoes were fairly easy to walk in. They are my favorite pairs of heels. and I do highly recommend them.
I will be buying more colors in the future, and I hope they will come out with more colors like brown and an aqua/blue shade.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 22, 2021
★★★★★ 5
Love this shoe style and color!
Size: 11, Color: Dark Sage Nbpu, Size: 11, Color: Dark Sage Nbpu
Love the shoe, comfortable and cute. The green is gorgeous! Happy with this purchase.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 24, 2026
★★★★★ 4
Cute
Size: 6.5, Color: Black (Pu)
Cute, comfortable.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 14, 2026
★★★★★ 5
Trying to get what's in picture
Size: 9, Color: Natural Nbpu
Amazon said my size was a 10. So i ordered a 10. Waaaay too long, wide big in general, and I have a wide foot so I was pleasantly surprised. Company did not offer any color in size 9.5 but according to their size guide I "might" fit into a 9! Again, pleasantly surprised that i totally did and even when I put in my "Dr. Scholl's" inserts, i have slight wiggle room for when feet swell. Overall I am happy with the shoe fit, comfortability and height...not that I'd wear these for more than 8 hrs., but comfy enough for a wedding or to wear to work when I have a "mostly office day" instead of out in the yard. HOWEVER... i loved the color and suede-ey look/feel pattern of the size 10. It was exactly as picture/info described. But I'm not sure what happened to the size 9? wth? Although i ORDERED exact same shoe/color but in smaller size...what I got was a much lighter color, and NOT the suede fabric...more nubuck. Bu inside of shoe had same info/tag as the 10. Really hoping that it was a packing/labeling error. Will try one more time to order the 9, in the same 'name' fabric. Fingers crossed that I get what I ordered/want. Otherwise it'll be a return and less stars.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 4, 2024
recommand products
Baseball - BBD008 - New York Mets - Baseball Dog Tag - Military Ball Chain - Luxury Dog Tag
29.95
Marvel Wall Art - MCU5028 - Iron Man - Electrifying Power in Action - Marvel Cinematic Universe Poster - Marvel Cinematic Universe Canvas
35.95
American Football - AFD015 - Detroit Lions NFL Super Bowl Spirit - American Football Dog Tag - Military Ball Chain - Luxury Dog Tag
29.95
American Football Wall Art - AF5251 - Oakland Raiders - NFL Football Team - American Football Poster - American Football Canvas
35.95
American Football Wall Art - AF5238 - Denver Broncos - NFL Football Team - American Football Poster - American Football Canvas
35.95